Linksys RV016 User Manual download pdf (Page 65)

Chapter 6: Setting up and Configuring the Router

VPN Tab - Gateway to Gateway

10/100 16-Port VPN Router

IP Range. If you select IP Range, then you can specify a range of IP addresses within the subnet that will be

able to access the tunnel. Complete the IP range fields. The default IP Range is 192.168.1.0~254.

Remote Group Setup

Before you configure the Remote Group Setup, make sure your VPN tunnel will have two different IP subnets. For

example, if the local 10/100 16-Port VPN Router has an IP scheme of 192.168.1.x (x being a number from 1 to

254), then the remote VPN router should have a different IP scheme, such as 192.168.2.y (y being a number from

1 to 254). Otherwise, the IP addresses will conflict, and the VPN tunnel cannot be created.

Remote Security Gateway Type

Select one of these five available types: IP Only, IP + Domain Name(FQDN) Authentication, IP + E-mail

Addr.(USER FQDN) Authentication, Dynamic IP + Domain Name(FQDN) Authentication, or Dynamic IP +

E-mail Addr.(USER FQDN) Authentication.

(If you want the remote VPN router to use a Fully Qualified Domain Name (FQDN) for authentication but it does not

have one, visit www.dyndns.org to set up a Dynamic Domain Name System (DDNS) account. Then enable and

configure the remote VPN router’s DDNS feature.)

The Remote Security Gateway Type you select should match the Local Security Gateway Type selected on the VPN

device at the other end of the tunnel.

After you have selected the Remote Security Gateway Type, the settings available on this screen may change,

depending on which selection you have made.

IP Only. If you select IP Only, then only the computer with a specific IP address will be able to access the

tunnel. In the IP address field, enter the IP address of the remote VPN device at the other end of the tunnel.

(This must be a static or fixed IP address only.)

IP + Domain Name(FQDN) Authentication. If you select this type, enter the FQDN (Fully Qualified Domain

Name) and IP address of the remote VPN device at the other end of the tunnel. (Enter the FQDN in the Domain

Name field, and enter the IP address in the IP address field.) The FQDN is the host name and domain name for

a specific computer on the Internet. An example of a FQDN is vpn.remotevpnserver.com. The FQDN and IP

address must match the FQDN and IP address of the Local Security Gateway type selected on the remote VPN

device at the other end of the tunnel. The FQDN and IP can be used for only one tunnel connection.

IP + E-mail Addr.(USER FQDN) Authentication. If you select this type, enter the e-mail address and IP address

of the remote VPN device at the other end of the tunnel.

Figure 6-60: Remote Security Gateway Type - IP Only

Figure 6-61: Remote Security Gateway Type -

IP + Domain Name (FQDN) Authentication

Figure 6-62: Remote Security Gateway Type -

IP + E-mail Addr. (USER FQDN) Authentication

Figure 6-59: Local Security Group Type - IP Range

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 126 127

No comments

Linksys RV016 User Manual Page 65