Linksys WMP54G User's Guide download pdf (Page 9)

1110

1. To install the Adapter, click the Install button on the Welcome screen,

Figure 5-1. Click User Guide to view the User Guide or click Exit to exit

the Setup Wizard.

2. After reading the License Agreement, shown in Figure 5-2, click the Next

button to continue the installation, or click the Cancel button to end the

installation.

3. The Setup Wizard will display a screen similar to that shown in Figure 5-3,

asking you to choose a wireless mode. Click the Infrastructure Mode

radio button if you want your wireless computers to network with comput-

ers on your wired network using a wireless access point. Click the Ad-Hoc

Mode radio button if you want multiple wireless computers to network

directly with each other. Do not use Ad-Hoc mode if you want your wire-

less computers to communicate with computers on your wired network.

Setup Wizard Instructions for Windows 98SE, Me, and 2000

Figure 5-2

Chapter 5: Software Installation

and Configuration for Windows

98SE, Me, and 2000

The Wireless-G PCI Adapter’s Setup Wizard will guide you through the instal-

lation procedure for Windows 98SE, Me, and 2000. The Setup Wizard will

install the WLAN Monitor and driver, as well as configure the Adapter.

Insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup

Wizard should run automatically, and Figure 5-1 should appear. If it does not,

click the Start button and choose Run. In the field that appears, enter

D:\setup.exe (if “D” is the letter of your CD-ROM drive).

Figure 5-1

Overview

Important for Windows 98SE, Me, and 2000 users: You must run

the Setup Wizard to install the software before installing the hardware.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

No comments

Linksys WMP54G User's Guide Page 9