Linksys BEFN2PS4 User Manual download pdf (Page 21)

Troubleshooting

Common Problems and Solutions

This section provides possible solutions to problems regarding the installation

and operation of the Cable/DSL Voice Router. Read below description to

solve your problems. If you can’t find an answer here, check the Linksys

website at www.linksys.com.

1. I Can’t connect to the Cable/DSL Router.

• The Cable/DSL Voice Router is properly installed, LAN connections

are OK, and it is powered ON.

• Ensure that your PC and the Cable/DSL Voice Router are on the same

network segment. If you are not sure, initiate the DHCP function, let

the PC get the IP address automatically.

• Ensure that your PC is using an IP Address within the default range of

192.168.1.2 to 192.168.1.254 and thus compatible with the Cable/DSL

Voice Router default IP Address of 192.168.1.1

• Also, the Subnet Mask should be set to 255.255.255.0 to match the

Cable/DSL Router. In the Cable/DSL Voice Router, you can check

these settings by using Control Panel-Network to check the Properties

for the TCP/IP protocol.

2. The Diag LED stays lit when it shouldn’t.

• The Diag LED lights up when the device is first powered up.

Meantime, the system will boot up itself and check for proper opera-

tion. After finishing the checking procedure, the LED turns off to show

the system is working fine. If the LED remains lit after this time, the

device is not working properly. Try to re-flash the firmware by assign-

ing a static IP address to the computer, then upgrade the firmware

again. If that doesn’t help, contact your dealer for further inspection.

3. I can’t browse through the Cable/DSL & Voice Router.

• Check if both ends of the network cable and power adapter are properly

connected. Check if the status LEDs on the front panel are functioning

properly.

• If using Windows 95 or Windows 98, check the TCP/IP setup on the

client side. Run "winipcfg" by clicking on the Start button, then select-

ing Run. The PC should have an IP address of 192.168.1.xxx ("xxx" is

from 2 to 254.) Subnet Mask is 255.255.255.0, the default gateway IP

EtherFast

Cable/DSL & Voice Router powered by Net2Phone

The Speed Dial setting allows users to program phone numbers that can be

dialed quickly using “shortcut” type words. Ten different numbers can be

input for speed dial through the voice router.

To program the “Fast Dial” option:

1. Enter the shortcut for the first telephone number you wish to program

into the first available “Fast Dial” box.

2. Enter the telephone number associated with that shortcut in the correspon-

ding phone number box.

3. Enter a description for the number in the “Description” box.

4. When calling, pick up the receiver and dial the shortcut of the telephone

number you wish to call. For example, the shortcut shown above would

be “*1”.

Speed Dial

Instant Broadband

Series

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Comments to this Manuals

No comments

Linksys BEFN2PS4 User Manual Page 21

Comments to this Manuals

Related products and manuals for Routers Linksys BEFN2PS4