Linksys CISCO WRT610N User Manual download pdf (Page 5)

Chapter 1

Product Overview

Simultaneous Dual-N Band Wireless Router

Chapter 1:

Product Overview

Thank you for choosing the Dual-Band Wireless-N Gigabit

Router with Storage Link. The Router lets you access the

Internet via a wireless connection or through one of its four

switched ports. With the built-in storage link, you can easily

add gigabytes of storage space onto your network using

USB 2.0 hard drives, or plug in a USB flash disk to access

your portable data files. The built-in media server streams

music, video and photos from the attached storage device

to any UPnP-compatible media adapter. Configuring the

Router is easy using the provided browser-based utility.

Front Panel

1, 2, 3, 4 (Green/Blue) These numbered LEDs,

corresponding with the numbered ports on the

Router’s back panel, serve two purposes. If the

LED is continuously lit, the Router is successfully

connected to a device through that port. A

flashing LED indicates network activity over

that port. The LED lights up Green when it is

connected to 10/100 port and Blue when it is

connected to a gigabit port.

Wi-Fi Protected Setup Button If you have

client devices, such as wireless adapters, that

support Wi-Fi Protected Setup, then you can

use Wi-Fi Protected Setup to automatically

configure wireless security for your wireless

network(s).

To use Wi-Fi Protected Setup, run the Linksys

Easy Link Advisor (LELA) , or refer to the “Wireless

> Basic Wireless Settings” section of “Chapter 3:

Advanced Configuration”.

Wi-Fi Protected Setup (WPS) LED (Blue/

Amber) The LED flashes blue for two

minutes during the WPS process and lights

up blue when the WPS process is successful.

The LED lights up amber if there is an error

during the Wi-Fi Protected Setup process. Make

sure the client device supports Wi-Fi Protected

Setup. Wait until the LED is off, and then try again.

The LED flashes when a Wi-Fi Protected Setup

session is active. The Router supports one

session at a time. Wait until the LED is solidly lit,

or off before starting the next Wi-Fi Protected

Setup session.

Wireless (Blue) The Wireless LED lights up

when the wireless feature is enabled. If the LED

is flashing, the Router is actively sending or

receiving data over the network.

Internet (Green/Blue) The Internet LED lights

up when there is a connection made through

the Internet port. A flashing LED indicates

network activity over the Internet port. The LED

lights up Green when it is connected to 10/100

port and Blue when it is connected to a gigabit

port.

USB (Blue) The USB LED lights up when a USB

device is attached. If the LED is flashing, the data

is being sent or received through this device.

Power (Blue) The Power LED lights up and will

stay on while the Router is powered on. When

the Router goes through its self-diagnostic

mode during every boot-up, this LED will flash.

When the diagnostic is complete, the LED will

be solidly lit.

Back Panel

USB Port For use with an external hard drive.

Internet The Internet port is where you will

connect your cable or DSL Internet connection.

1, 2, 3, 4 These Ethernet ports (1, 2, 3, 4) connect

the Router to PCs on your wired network and

other Ethernet network devices.

Reset There are two ways to reset the Router’s

factory defaults. Either press and hold the Reset

Button for approximately five seconds, or restore

the defaults from Administration > Factory

Defaults in the Router’s web-based utility.

Power The Power port is where you will

connect the power adapter.

1 2 3 4 5 6 7 8 9 10 ... 57 58

Comments to this Manuals

No comments

Linksys CISCO WRT610N User Manual Page 5

Comments to this Manuals

Related products and manuals for Routers Linksys CISCO WRT610N