Linksys WIRELESS-G WRT54GS User Manual download pdf (Page 30)

Chapter 5: Configuring the Wireless-G Broadband Router

The Wireless Tab - Wireless Security

Wireless-G Broadband Router with SpeedBooster

The Wireless Tab - Wireless Security

The Wireless Security settings configure the security of your wireless network. There are six wireless security

mode options supported by the Router: WPA Personal, WPA Enterprise, WPA2 Personal, WPA2 Enterprise, RADIUS,

and WEP. (WPA stands for Wi-Fi Protected Access, which is a security standard stronger than WEP encryption.

WEP stands for Wired Equivalent Privacy, while RADIUS stands for Remote Authentication Dial-In User Service.)

These six are briefly discussed here. For detailed instructions on configuring wireless security for the Router, turn

to “Appendix B: Wireless Security.”

WPA Personal. WPA gives you two encryption methods, TKIP and AES, with dynamic encryption keys. Select the

type of algorithm, TKIP or AES. Enter a WPA Shared Key of 8-63 characters. Then enter a Group Key Renewal

period, which instructs the Router how often it should change the encryption keys.

WPA Enterprise. This option features WPA used in coordination with a RADIUS server. (This should only be used

when a RADIUS server is connected to the Router.) First, select the type of WPA algorithm you want to use, TKIP

or AES. Enter the RADIUS server’s IP Address and port number, along with a key shared between the Router and

the server. Last, enter a Key Renewal Timeout, which instructs the Router how often it should change the

encryption keys.

Figure 5-19: Wireless Tab - Wireless Security

(WPA Personal)

Figure 5-20: Wireless Tab - Wireless Security

(WPA Enterprise)

IMPORTANT: If you are using WPA, always

remember that each device in your wireless

network MUST use the same WPA method

and shared key, or else the network will not

function properly.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 88 89

No comments

Linksys WIRELESS-G WRT54GS User Manual Page 30