Linksys WAP610N User Manual download pdf (Page 4)

Chapter 1

Product Overview

Wireless-N Access Point with Dual-Band

Chapter 1:

Product Overview

Thank you for choosing the Linksys by Cisco

Wireless-N Access Point with Dual-Band. The Wireless-N

Access Point with Dual-Band adds wireless capability to

your existing wired network, or upgrades older wireless

networks to Wireless-N performance. For first-time

installation, run the Setup Wizard on the enclosed CD.

To configure advanced settings, use the convenient,

browser-based utility.

LEDs Panel

Wireless (Blue) The Wireless LED lights up

when there is a wireless connection. The LED

flashes when the Access Point is actively sending

or receiving data over the wireless network.

Wi-Fi Protected Setup™ Button If you have

client devices, such as wireless adapters, that

support Wi-Fi Protected Setup™, then you can

use Wi-Fi Protected Setup™ to automatically

configure wireless security for your wireless

network. To use Wi-Fi Protected Setup™, run

the Setup Wizard, or refer to “Wireless > Basic

Wireless Settings” on page 4.

Wi-Fi Protected Setup™ LED (Blue/Amber)

The LED flashes blue for two minutes during

Wi-Fi Protected Setup™. It lights up blue when

wireless security is enabled. If there is an error

during the Wi-Fi Protected Setup™ process,

then the LED lights up amber. Make sure the

client device supports Wi-Fi Protected Setup™.

Wait until the LED is off, and then try again.

Ethernet (Blue) The Ethernet LED lights up

when there is a wired connection. The LED

flashes when the Access Point is actively sending

or receiving data over the Ethernet port.

Power (Blue) The Power LED lights up when

the Access Point is powered on.

Ports Panel

Ethernet The Ethernet port connects the

Access Point to a router.

Reset There are two ways to reset the Access

Point’s factory defaults. Either press and

hold the Reset button for approximately five

seconds, or restore the defaults from the

Administration > Factory Defaults screen in the

Access Point’s browser-based utility.

Power The Power port connects the Access

Point to the included power adapter.

1 2 3 4 5 6 7 8 9 ... 40 41

Comments to this Manuals

No comments

Linksys WAP610N User Manual Page 4

Comments to this Manuals

Related products and manuals for Hardware Linksys WAP610N