Linksys WAPPOE12 User Manual download pdf (Page 4)

Chapter 1

Product Overview

12 Volt Power Over Ethernet Adapter Kit

Chapter 1:

Product Overview

Introduction

Thank you for choosing the Linksys 12 Volt Power Over

Ethernet Adapter Kit, comprised of the Injector and

Splitter. The Injector sends power and data over the

Ethernet cable to the Splitter. Then the Splitter separates

the data and power back into two cables and delivers

them to the remotely located access point or other

network device that requires a 12-volt power input. The

Injector can also be used by itself with any Power Over

Ethernet (POE)-enabled network device that accepts

48 volts directly on a POE port.

NOTE: If your Linksys product uses a 5-volt

power input, then you should use the 5-volt kit,

model number: WAPPOE.

This is a list of compatible Linksys products, alphabetized

by model number:

ADSLMUE1 (all versions) - ADSL Modem with USB & •

Ethernet

AG041 - ADSL Gateway with 4-Port Switch •

BEFSX41 (versions 1 and 2) - Broadband Firewall Router •

with 4-Port Switch/VPN Endpoint

BEFW11S4 (version 4) - Wireless-B Broadband Router •

RT31P2 - Broadband Router with 2 Phone Ports •

WAG54G (versions 1.2 and 2) - Wireless-G ADSL •

Gateway

WAP54G (version 2) - Wireless-G Access Point •

WCG200 (all versions) - Wireless-G Cable Gateway •

WGA54G - Wireless-G Game Adapter •

WPS54GU2 - Wireless-G PrintServer for USB 2.0 •

WRK54G - Wireless-G Broadband Router •

WRT54G - Wireless-G Broadband Router •

WRT54GS - Wireless-G Broadband Router with •

SpeedBooster

WRT54GP2 - Wireless-G Broadband Router with 2 •

Phone Ports

Injector

The Injector’s built-in cable and ports are located on side

panels.

Injector’s First Side Panel

The Power & Data OUT port is located on the Injector’s first

side panel.

Power & Data OUT This port allows you to

connect the Injector to the Splitter or a network

device that supports inline power. (You will use

the included Ethernet network cable to make

this connection.)

Injector’s Second Side Panel

The built-in Ethernet network cable and Power port are

located on the Injector’s second side panel.

Power The Power port is where you will

connect the included adapter.

Ethernet IN The Injector has a built-in Ethernet

network cable. You will connect this cable to one

of the Ethernet network ports on your router or

switch.

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Linksys WAPPOE12 User Manual Page 4

Comments to this Manuals

Related products and manuals for WLAN access points Linksys WAPPOE12