Linksys WAP54GP User Manual download pdf (Page 13)

Chapter 3: Getting to Know the Wireless-G Access Point with Power Over Ethernet

The Back Panel

Wireless-G Access Point with Power Over Ethernet

The Back Panel

The Access Point's Ethernet network and power ports, as well as the Reset button, are located on the back panel.

Ethernet Port The Ethernet network port connects to an Ethernet network device, such as a switch or router.

Reset Button There are two ways to Reset the Access Point's factory defaults. Either press the Reset

button, for approximately ten seconds, or restore the defaults using the Access Point's Web-

based Utility.

Power Port The Power port connects to the Access Point’s power adapter. (This port will not be used if you

are using Power Over Ethernet.)

Figure 3-2: Back Panel

port: the connection point on a computer or

networking device used for plugging in

cables or adapters

IMPORTANT: Resetting the Access Point will erase all of your settings

(including wireless security, IP address, and power output) and replace them

with the factory defaults. Do not reset the Access Point if you want to retain

these settings.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 66 67

No comments

Linksys WAP54GP User Manual Page 13