Linksys WAP54GP User Manual download pdf (Page 65)

Appendix H: Regulatory Information

Wireless-G Access Point with Power Over Ethernet

Italy

This product meets the National Radio Interface and the requirements specified in the National Frequency Allocation Table

for Italy. Unless operating within the boundaries of the owner’s property, the use of this 2.4 GHz Wireless LAN product

requires a ‘general authorization’. Please check with http://www.comunicazioni.it/it/ for more details.

Questo prodotto è conforme alla specifiche di Interfaccia Radio Nazionali e rispetta il Piano Nazionale di ripartizione delle

frequenze in Italia. Se non viene installato all’interno del proprio fondo, l’utilizzo di prodotti Wireless LAN a 2.4 GHz richiede

una “Autorizzazione Generale”. Consultare http://www.comunicazioni.it/it/ per maggiori dettagli.

Product Usage Restrictions

This product is designed for indoor usage only. Outdoor usage is not recommended.

This product is designed for use with the standard, integral or dedicated (external) antenna(s) that is/are shipped together

with the equipment. However, some applications may require the antenna(s) to be separated from the product and

installed remotely from the device by using extension cables. For these applications, Linksys offers an R-SMA extension

cable (AC9SMA) and an R-TNC extension cable (AC9TNC). Both of these cables are 9 meters long and have a cable loss

(attenuation) of 5 dB. To compensate for the attenuation, Linksys also offers higher gain antennas, the HGA7S (with R-SMA

connector) and HGA7T (with R-TNC connector). These antennas have a gain of 7 dBi and may only be used with either the

R-SMA or R-TNC extension cable.

Combinations of extension cables and antennas resulting in a radiated power level exceeding 100 mW EIRP are illegal.

Power Output of Your Device

To comply with your country’s regulations, you may have to change the power output of your wireless device. Proceed to

the appropriate section for your device.

Wireless Adapters

Wireless adapters have the power output set to 100% by default. Maximum power output on each adapter does not exceed

20 dBm (100 mW); it is generally 18 dBm (64 mW) or below. If you need to alter your wireless adapter’s power output,

follow the appropriate instructions for your computer’s Windows operating system:

Note: The power output setting may not be available on all wireless products. For more information, refer to

the documentation on your product’s CD or http://www.linksys.com/international.

1 2 ... 60 61 62 63 64 65 66 67

No comments

Linksys WAP54GP User Manual Page 65