Linksys SPA9000 User Manual Page 45
- Page / 128
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
38
Chapter 6: Using the Web-based Utility
The Voice Tab
IP Telephony System
INFOREQ Dynamic Payload. This is the INFOREQ dynamic payload type. There is no default.
G726r16 Dynamic Payload. This is the G726-16 dynamic payload type. The default is 98.
G726r24 Dynamic Payload. This is the G726-24 dynamic payload type. The default is 97.
G726r40 Dynamic Payload. This is the G726-40 dynamic payload type. The default is 96.
G729b Dynamic Payload. This is the G729b dynamic payload type. The default is 99.
NSE Codec Name. This is the NSE codec name used in SDP. The default is NSE.
AVT Codec Name. This is the AVT codec name used in SDP. The default is telephone-event.
G711u Codec Name. This is the G711u codec name used in SDP. The default is PCMU.
G711a Codec Name. This is the G711a codec name used in SDP. The default is PCMA.
G726r16 Codec Name. This is the G726-16 codec name used in SDP. The default is G726-16.
G726r24 Codec Name. This is the G726-24 codec name used in SDP. The default is G726-24.
G726r32 Codec Name. This is the G726-32 codec name used in SDP. The is G726-32.
G726r40 Codec Name. This is the G726-40 codec name used in SDP. The default is G726-40.
G729a Codec Name. This is the G729a codec name used in SDP. The default is G729a.
G729b Codec Name. This is the G729b codec name used in SDP. The default is G729ab.
G723 Codec Name. This is the G723 codec name used in SDP. The default is G723.
NAT Support Parameters
Handle VIA received. If you select yes, the System will process the received parameter in the VIA header (this is
inserted by the server in a response to any one of its requests). If you select no, the parameter will be ignored.
Select yes or no from the drop-down menu. The default is no.
Handle VIA rport. If you select yes, the System will process the rport parameter in the VIA header (this is
inserted by the server in a response to any one of its requests). If you select no, the parameter will be ignored.
Select yes or no from the drop-down menu. The default is no.
Figure 6-19: Voice - SIP Screen - NAT Support
Parameters
VoIPon Solutions www.voipon.co.uk [email protected] Tel: +44 (0) 1245 600560
- IP Telephony 1
- Copyright and Trademarks 2
- How to Use this Guide 2
- Table of Contents 3
- List of Figures 5
- Chapter 1: Introduction 8
- What’s in this Guide? 9
- IP Telephony System 10
- A Typical Scenario 11
- The Back Panel 13
- The Front Panel 14
- Chapter 4: Getting Started 15
- Internal Calls 16
- Connect the Internet Phones 18
- External Calls 19
- Action Command 22
- (press these 22
- Choices Description 22
- Entering a Password 26
- Auto-Attendant Messages 27
- 1 to Record 28
- 2 to Review 28
- 3 to Delete 28
- * to Exit 28
- The PBX Status Screen 30
- Parking Lot 31
- Line 1 Calls 31
- The Router Tab 32
- The Router - WAN Setup Screen 34
- MAC Clone Settings 35
- Remote Management 35
- QOS Settings 35
- The Router - LAN Setup Screen 36
- Port Forwarding Settings 37
- DMZ Settings 37
- System Reserved Ports Range 37
- The Voice Tab 38
- Line 1/2/3/4 Status 40
- Auto Attendant Prompt Status 40
- The Voice - System Screen 41
- The Voice - SIP Screen 42
- SIP Timer Values (sec) 43
- Response Status Code Handling 44
- RTP Parameters 44
- SDP Payload Types 44
- NAT Support Parameters 45
- PBX Parameters 46
- Auto Attendant Parameters 49
- PBX Phone Parameters 51
- Configuration Profile 52
- Firmware Upgrade 53
- General Purpose Parameters 54
- The Voice - Regional Screen 55
- Distinctive Ring Patterns 56
- Control Timer Values (sec) 58
- Miscellaneous 63
- The Voice - FXS 1/2 Screen 66
- Subscriber Information 67
- Dial Plan 68
- Streaming Audio Server (SAS) 68
- Call Feature Settings 68
- Audio Configuration 69
- Network Settings 72
- SIP Settings 72
- NAT Settings 75
- Proxy and Registration 75
- Appendix A: Troubleshooting 77
- For Windows 2000: 80
- For Windows XP: 80
- Ending Ports 84
- Protocol IP Address 84
- For Netscape 4.7 or higher: 86
- Frequently Asked Questions 87
- 4 “Goodbye.” 90
- Recording a New Prompt 91
- Advanced Users 94
- AA Dial Plan 1 dp1 96
- AA Dial Plan 2 dp2 96
- Internal Dial Plan 97
- 4“Goodbye.” 98
- Parameter Description Type 101
- Parameter Value 103
- Overview 106
- Before You Begin 106
- Ethernet Adapter 109
- Appendix F: Windows Help 111
- Appendix G: Glossary 112
- Appendix H: Specifications 117
Related products and manuals for Networking Linksys SPA9000
Networking Linksys WET54GS5 User Manual
(69 pages)
(69 pages)
Networking Linksys EG0801SK User Manual
(44 pages)
(44 pages)
Networking Linksys PCMLM56 User Manual
(29 pages)
(29 pages)
Networking Linksys USB100TX User Manual
(28 pages)
(28 pages)
Networking Linksys EG24M User Manual
(46 pages)
(46 pages)
Networking Linksys HM-BT-VIN User Manual
(8 pages)
(8 pages)
Networking Linksys EG1032 V3 User Manual
(46 pages)
(46 pages)
Networking Linksys NULL WPC55AG User Manual
(27 pages)
(27 pages)
Networking Linksys USB1000 User Manual
(26 pages)
(26 pages)
Networking Linksys USB200HA User Manual
(22 pages)
(22 pages)
Networking Linksys WTR54GS User Manual
(86 pages)
(86 pages)
© 2020, manymanuals.com. All rights reserved. | 1.160 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals