Linksys SPA9000 User Manual download pdf (Page 67)

Chapter 6: Using the Web-based Utility

The Voice Tab

IP Telephony System

excl. NTFY to log the start-line only for all messages except NOTIFY requests/responses. Select 1-line excl. REG

to log the start-line only for all messages except REGISTER requests/responses. Select 1-line excl.

OPT|NTFY|REG to log the start-line only for all messages except OPTIONS, NOTIFY, and REGISTER

requests/responses. Select full to log all SIP messages in full text. Select full excl. OPT to log all SIP messages

in full text except OPTIONS requests/responses. Select full excl. NTFY to log all SIP messages in full text except

NOTIFY requests/responses. Select full excl. REG to log all SIP messages in full text except REGISTER

requests/responses. Select full excl. OPT|NTFY|REG to log all SIP messages in full text except for OPTIONS,

NOTIFY, and REGISTER requests/responses. The default is none.

RTP Log Intvl. Periodically, the System will log RTP statistics via syslog, depending on debug level. Enter the

period of time in seconds. The default is 0.

Restrict Source IP. If Lines 1 and 2 use the same SIP Port value and the Restrict Source IP feature is enabled,

then the proxy IP address for Lines 1 and 2 is treated as an acceptable IP address for both lines. To enable the

Restrict Source IP feature, select yes. Otherwise, select no. The default is no.

Referor Bye Delay. This controls when the System sends BYE to terminate stale call legs upon completion of call

transfers. Multiple delay settings (Referor, Refer Target, Referee, and Refer-To Target) are configured on this

screen. For the Referor Bye Delay, enter the appropriate period of time in seconds. The default is 4.

Refer Target Bye Delay. For the Refer Target Bye Delay, enter the appropriate period of time in seconds. The

default is 0.

Referee Bye Delay. For the Referee Bye Delay, enter the appropriate period of time in seconds. The default is 0.

Refer-To Target Contact. To contact the refer-to target, select yes. Otherwise, select no. The default is no.

Sticky 183. If this feature is enabled, then the IP Telephony will ignore further 180 SIP responses after receiving

the first 183 SIP response for an outbound INVITE. To enable this feature, select yes. Otherwise, select no. The

default is no.

Subscriber Information

Display Name. Enter the display name for caller ID.

User ID. Enter the extension number for this line.

Figure 6-38: Voice - FXS 1 Screen - Subscriber

Information

VoIPon Solutions www.voipon.co.uk [email protected] Tel: +44 (0) 1245 600560

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 127 128

No comments

Linksys SPA9000 User Manual Page 67